BitEdit Bosch ME17.8.8

Software module for editing calibrations Bosch ME17.8.8 and Bosch ME17.8.8.1 ECUs of petrol normal aspirated and turbocharged vehicles from China market.

Supported maps:

• Air control: Airmass flow through throttle valve, Throttle valve position, Accelerator pedal map
• Boost: Wastegate duty cycle target/linerisation, P-controller, Regulation basis, Boost limitations
• Exhaust gas temperature
• Idle: Desired idle speed AT/MT, Desired idle speed with A/C, Minimal idle speed
• Knock control: Knock sensor sensetivity per cylinder, Retardation step, Retardation recovery
• Limiters: Engine speed limitation
• Spark advance: Base spark advance, Minimal spark advance, Optimal spark advance, Spark advance correction from lambda
• Switch operation modes: Requested torque threshold to enter full load, Throttle position for full load detection
• Target lambda: Target lambda at part load, Full load, Acceleration, Warm up, Delay before entering acceleration, Delta correction
• Torque limitation: Monitoring torque limitation, Offset tolerance for allowed torque, Maximal torque
• Torque model: Driver requested torque, Optimal indicated torque, Target air filling from torque, Ignition angle efficiency, Indicated torque limitation, Lambda efficiency, Minimal efficiency
• VVT: Intake camshaft position
• Fan control: Switching on/off coolant
• Injector control: Injection end timing
• DTC: DTC mask editor

discover all BitEdit products from here