BitEdit Module Delphi MT05

Module Delphi MT05 / MT05.2 / MT05.3

Calibration editing for Delphi MT05 ECUs with 128Kb, 256Kb, and 1.5Mb files.

Supported Maps (MT05/05.2):

• Air: Base air fill, VE (idle/part load), VE correction via PAtm, Throttle full load threshold
• Idle: Idle injection & speed correction, Desired RPM, Idle spark, Idle lambda
• Lambda: Target lambda (full/part load), Temp-based corrections, Stoichiometric A/F
• Limiters: RPM & speed limiters (with recovery)
• Scalings: Coolant/IAT sensor, TPS fault detection, Injector scaling
• Spark: Base/part/full load advance, Temp corrections, Dwell time
• Start: Idle actuator, Start spark, Lambda at start
• DTC: DTC mask support

Supported Maps (MT05.3 1.5Mb):

• Air: Nominal charge, VE, VE via PAtm
• Fuel: Enrichment, Injector temp correction
• Idle: Temp-based RPM, Start spark
• Lambda: Idle (temp/pressure), WOT, Partial load
• Limiters: RPM & speed limiters
• Scalings: Coolant/IAT sensor, TPS fault
• Spark: Full map incl. WOT, idle, temp corrections, dwell

discover all BitEdit products from here