Parts Washer 20 Gallon

Tank capacity: 20 Gallon

Solvent capacity: 12 Gallon

Max. pump output: 2.7-3.3 L/min

Electrical Requirement: 120V, 60Hz/240V, 50Hz

Operation 

1. Fill only with a non-flammable degreaser or cleaning agent, to just below the level of the parts shelf.

DO NOT fill with flammable solvents such as paraffin, thinners, etc.

2. Open the lid, switch the pump on, and hold the part to be cleaned under the nozzle, slowly rotating the component until clean.

3. When clean, leave to drain on the tray or in a small component container until dry.

4. Switch off the pump, close the lid, and disconnect the power supply.

5. Remove gloves and goggles, store safely.

IMPORTANT:

1. The Lid Stay incorporates a safety device in the form of a fusible link, which closes the lid in the event of a fire. The link is non-resetting and must be replaced should it be activated.

2. Clean the pump filter regularly by sliding it away from the pump housing and rinsing it in clean degreaser.

3. Do not allow the level of liquid in the parts washer to fall below the pump inlet, as damage to the pump can result.

discover all Parts Washer from here