Software module for editing calibrations Denso ECU of petrol Toyota | Lexus | Scion vehicles with engines 3.0, 3.3 and 3.5 litres with ECUs Denso 89661-xxxxx and MCU NEC 76F0038, 76F0039, 76F0040, 76F0070, 76F0085 inside.

Available Maps for Editing

• Air Calculation: Calculated air load from requested torque, Mass air flow pulsations factor
• Automatic Transmission Downshift Conditions: Output Speed vs Throttle in different modes
• Automatic Transmission Torque Converter: Various speed and throttle control maps
• Automatic Transmission Torque Converter Flex: Normal and Sport mode configurations
• Automatic Transmission Upshift Conditions: Output Speed vs Throttle in different modes
• Exhaust Temperature Model: Various temperature offsets and protection limits
• Fuel Enrichment: Injection time correction, minimal injection times, injector dead time
• Idle Speed: Desired idle speed settings, idle spark advance controls
• Limiters: Engine speed and vehicle speed limitations
• Sensor Scaling: Intake air temperature and mass air flow sensor scaling
• Spark Advance: Base spark advance, efficiency delta, high/low octane adjustments
• Spark Advance Correction: Adjustments based on coolant temperature and VVT
• Spark Advance Knock Control: Thresholds, retardation limits, and recovery rates
• Spark Advance Minimal: Minimal base settings and temperature corrections
• Startup: Startup time and engine speed adjustments
• Throttle Valve Control: Various throttle position limitations per gear and load conditions
• Torque Converter General: Coolant and oil temperature-based control maps
• Torque Model: Optimal torque settings for transmission
• VVT: Exhaust and intake camshaft position settings for various loads and throttle levels
• Warm Up: Coolant temperature thresholds and warm-up corrections
• DTC Mask Editor

discover all BitEdit software from here