Software module for editing calibrations Denso Gen3 ECU of normal aspirated petrol Toyota | Lexus.

Supported engine types: A25A, M20A, M15A.

Supported filesize: 4Mb.

Available Maps

• Air calculation: Injection in closed loop mode, Target air load
• Limiters: Engine speed limitation
• Exhaust temperature model: Target exhaust temperature
• Fuel: Fuel quantity limiter, Injector characteristic, Injector opening time, Per cylinder enrichment multiplier
• Fuel pressure: Target fuel pressure, Fuel pressure limiter
• Idle speed (if found, TEST): Idle speed in additional mode
• Ignition: Ignition advance angle characteristic map, Minimal spark advance, Optimal ignition advance angle, Spark advance idle, Spark advance retardation angle, Spark advance warm-up correction
• Input sensors: Temperature sensor conversion curve
• Lambda: Power enrichment, Target lambda in additional mode
• Torque: Optimal indicated torque, Optimal torque for transmission, Requested torque, Air load limiter, Effective torque limiter, Indicated torque limiter, Torque limiter
• Torque Converter - General: Coolant temperature to disable hot mode, Coolant temperature to enable hot mode, Oil temperature for high coolant disable, Oil temperature threshold for high coolant temperature enable, Oil temperature threshold to disable hot mode, Oil temperature to enable hot mode
• Automatic transmission: downshift conditions (if present in the file)
• Automatic transmission: torque converter (if present in the file)
• Automatic transmission: torque converter flex (if present in the file)
• Automatic transmission: upshift conditions (if present in the file)
• DTC

discover all BitEdit software from here