AutoTuner Tool Device Master Version
Manufacturer: AutoTuner Tool
Autotuner is characterised by its single fee package, its ease of use and high efficiency.
Autotuner is a universal tool able to read information from most ECUs and microcontrollers available on the market in boot tricore Infineon (BSL) or via the OBD diagnostic socket.
Autotuner is being constantly improved with new reading protocols. You can freely benefit from it as soon as you start your Autotuner Software.
Thanks to the ECU communication optimization and its Cortex m4 processor, memory content (Dflash Eflash and EEprom) reading is ultra-fast. It then systematically performs a backup of the TriCore password online.
All-in one package ready to use
Autotuner is delivered with all the required accessories in a dedicated package.
All compatible cars are displayed as a list so that you can quickly and easily select the ECU you want to read.
Specific help section is available in the software
Autotuner helps you locate the ECU or OBD diagnostic socket on the vehicle.
It then guides you step by step through the process of reading and illustrates each step with high-definition photos.
All information is continuously updated and free of charge.
A tool is continuously updated, for free !
5 years warranty!
Autotuner tool is under 5 years warranty. Should you encounter any major problem, we will organize replacement immediately.
ALL THE FEATURES YOU NEED IN A HIGH-PERFORMANCE TOOL.
READING AND WRITING OF ENGINE CONTROL UNITS AND GEARBOXES
Autotuner can read data from most of the ECUs and microcontrollers on the market.
AUTOMATIC CHECKSUM CORRECTION
Checksum correction is done automatically by the tool during the writing process. There is no need to calculate the Checksum yourself.
The Autotuner datalogging feature has been designed to be easy to use. For each supported ECU, we have pre-selected a set of relevant data depending on the vehicle and manufacturer's specific parameters.
BACK TO STOCK
Do you want to start from a sound and up-to-date base? Start by restoring the vehicle to its original state by using the “back to stock” function.
Reading and deletion of Diagnostic Trouble Codes (DTC) that are generic and manufacturer-specific via the OBD-II socket.
With a master tool you get non encrypted files so you can modify the files by yourself or send it to any tuning files provider.
Any editing software that supports binary file can be used to modify a file read with Autotuner.
With a slave tool you read and write crypted files. These files can only be modified by a specific master. This master is a file provider designated when you buy the tool. Your slave tool is linked to this master.
Any slave tool can be remotely transformed into master tool if the following conditions are met :