Ballon Jack With Metal Head 3ton

Matters needing attention:

1. This lifting jack is only used in the process of rising and falling. If supporting the cart, please use the safety stands. This product can only be used for the skirt part of the car.

2. Please use it on a relatively level, solid ground.

3. Please place a triangle block under the car's dependency wheel.

4. The normal operating pressure is in the range of 5-10 kg/cm².

5. Compressed air should be clean and contain no water.

6. There is no need to raise the balloon to the maximum, as long as to the desired height (such as to cram off the ground), that is, close the ball value switch, stop the gas supply, cram the safety brachet, and then work.

7. Remember that if the balloon rises to its maximum (Stop to Rise), immediately shut off the valve seat and stop the gas supply

8. When used, the jack should take a position 10-20 cm outside the center; that is, the jack should be placed just a little under the car.

9. The safety value has been set as 10 kg/cm². If exceeded, the pressure will be automatically discouraged. If it doesn't work, please correct it again.

10. When not in use, it should be placed indoors and must not be placed outdoors. And please use the supplied accessories.

11. It is strictly prohibited to disassemble the jack balloon; otherwise, there will be consequences to bear. At the same time, the manufacturer is not responsible for after-sale service

instructions for use : 

When inflated, the jack rides and vice-versa.

1. To control the switch in the rod back, insert the compressed air into the rigt gas nozzle, and close the left switch.

2. Open the right ball value switch, and when the gasbag rises, it can be used.

3. To fall the jack, please open the left switch

Ballon Jack With Metal Head 3ton

discover all Transmission Jack from here