- New
Mega ME01370 CE Cooling System Vacuum Purge & Refill Kit Radiator
Mega ME01370 CE Cooling System Vacuum Purge & Refill Kit Radiator
Dramatically reduces cooling system refill time, without mess and without introducing air-locks.
.No more time consuming cooling system bleeding and no more messy spills to clean up.
.Simply plug into the workshop air line, attach to the cooling system header tank and create a vacuum.
.Complete the process by attaching the filler hose and opening the valve allowing your pre-mixed coolant to flow into the system.
.Supplied in the blow moudle case.
Direction of use:
CREATE A VACUUM
1.Drain coolant from the radiator.
2.Select a suitable sized rubber bush, fitting it to the lower part of main body, and connect it to the radiator filler neck. When tighten the screw on the main body, the rubber bush will be squeeze to fit securely the filler neck.
3.Connect the vacuum pump to the main body.
4.Connect the air line to the top of the vacuum pump.
5.Open the valve to create a vacuum in the cooling system. When the gauge reading falls into the range between -50 to -60 (-0.7 to -0.8 Bar), turn off the valve.
REFILL NEW COOLANT
1.Disconnect the air line and the vacuum pump.
2.Connect the coolant hose to the quick coupler.
3.Put the hose into a container filled with pre-mixed coolant. Make sure there is sufficient amount of coolant to be refilled into the cooling system.
4.Turn on the valve and the coolant would flow into the radiator. The refilling process is done when the gauge reads zero. Make sure if the coolant is refilled with an adequate amount.
5.Disconnect the air line and hose. Clean all the residual coolant in the devices before storage.
No customer reviews for the moment.