- New
WOYO BOLT REMOVER HBR007
AED1,500.00
WOYO BOLT REMOVER HBR007
Security policy(edit with the Customer Reassurance module)
Delivery policy(edit with the Customer Reassurance module)
Fast Delivery(edit with the Customer Reassurance module)
WOYO BOLT REMOVER HBR007
WOYO HBR Induction Heating Bolt Remover Machine for Rusted / Frozen / Corrosive Bolt / Nut from Car and Machine
WOYO HBR is a flameless tool that can quickly and easily loosen rusted-on bolts.
1.The Heat Induction technology used is flameless, safe, and environmentally friendly. It greatly reduces the risk of accidents and potential damages.
2.Works in thirty seconds without damaging either the bolt or the surrounding equipment.
3.Easy to use, can be mastered in only three minutes!
4.Comes equipped with an LED light, for use in tight spaces.
5.Choose from multiple coils, each suited to different type bolts.
6.The size of two books, it’ll save you space and capital investment compared to flame-based tools.
7.WOYO HBR012 is not limited to use on cars, farm equipment, boats and tanks, it is well suited to any machine repair job!
Heating Bolt Rmover Operational Considerations
1.Top prolong your heating inductor,leaving an 10mm air gap between the coil and the work piece is
recommended as the isulation of the coil will eventually burn through if held directly to hot material
2.Choose the appropriately sized coil to give the closet fit to the work piece.
3.Insert both ends of the coil into the coil location socket and tighten the thumb screws securely
4.Activatie the power switch to run the heating inductor for 1-3 minutes until enough heat has been applied to the work piece to break
the rust/corrosion bond.
5.Release the power swith to turn off the power.
6.Do not use portable generators. The unstable voltage will damage the unit and void the warranty
7.Turn off unit and allow the unit and all attchment to cool for at least 20 minutes.
Handling the unit or parts befor they have cooled may result in injury.
8.Make sure the unit is turned off and unplugged.
After cool enough, use a dry,clean,non-abrasive cloth or paper towel to remove grease,oil and other dirt from the heating
inductor and electrical lead before returning them to the storage case.
Storage of unit while still hot may result in damage to equipment or pose a fire hazard.
Package includes:
1pc x HBR Main
1pc x Flexible Soft Coil (110cm)
1pc x 1.8cm coil ( diameter of bore ) ( Length 20cm )
1pc x 2.2cm coil ( diameter of bore ) ( Length 20cm )
1pc x 2.8cm coil ( diameter of bore ) ( Length 20cm )
2pc x Screw
1pc x Manual
10 Items
Specific References
No customer reviews for the moment.
You might also like
WOYO BOLT REMOVER HBR007
WOYO BOLT REMOVER HBR007
AED1,500.00